UPDATE

I added a version 2 that's actually the exactly the same just +.1mm longer for (hopefuly) a tighter press fit although I have no tested it yet, so let me know. I also put a slight fillet on the edges

I made a tool organizer that fits the little right side indentation along the top of the USCutter's SC2 vinyl cutter. I added 2 spots for blade housings as well as a slot for the extra blade container. Since I had some more room I figured I'd throw in the slots from asay008's weeding tool organizer. I haven't fit the rest of the tools (waiting on my weeding tools) so that may be updated in the future if things end up too close to each other.

Notes:

The indent its sits in is only about 2mm-3mm deep, but does seem to have a slight press fit feel even though is a very shallow indentation. Perhaps if I need to update it I'll increase the length around .1mm-.2mm to make up for some slightly shrinkage from the printed material to get an even tighter fit. I used PLA, but if you dont wana wait you could prob scale it up very slightly and use TPU so the material have more give when press fitting than rigid PLA