This is a remixed TX03 Camera mount designed for the Eachine Micro Skyhunter.

Not yet tested; but designed to screw into pre-drilled 20mm separated holes on the canopy section. Holes on the mount are designed to take M2 (2mm) self-tapping screws to affix to the FPV canopy, and will accept screws with heads up to 6mm (which should include flanged heads too).

Also added a flat front and gradient edge to the camera base to allow for support-less printing. Rounded the back edges off for aesthetics and weight reduction.

Retained the zip-tie gap under the camera (enlarged as I only have slightly too big ties for the original hole size), as I plan to loosely ziptie the camera to the mount as a backup. Will screw (and hot glue to be safe) the mount itself into place on the plane (note: these cameras often get too hot for using hotglue to secure it in place).

I printed at 3 wall, 1.2mm top+bottom, 100% infill, and it's looking good. Very light and strong in PLA.

Chinese Ebay i3 Clone

Doesn't Matter

Doesn't Matter

0.1

100%