Since uploading my Ender 5 Plus Micro Swiss cable support bracket, I have redesigned a bracket to fit at the end of the X Gantry to mount the cable on to support it away from the metal frame and the wheels on the gantry.

You will need to install this with 2x M5 blots and T Nuts.

Once it has been bolted on to clear the wheels and frame work, then slide the X carriage to the extreme left, and the Y carriage to the extreme front.

Hold the cable trunking against the bracket to make sure there is sufficient slack in both the X and the Y movement, then cable tie the trunking to the bracket.

MicroSwiss Direct drive bracket here: https://www.thingiverse.com/thing:5181898

Cable support bracket here: https://www.thingiverse.com/thing:4796135

Category: 3D Printer Accessories