The Easy Print Planter is a self-watering planter that prints in one piece, WITHOUT supports! To use, pour water into the reservoir until the floater is 2 inches above the top of the pot. Don't forget to refill whenever the water-level floater dips below the top of the pot!

Print Settings

Printer Brand:

Creality

Printer: 

Ender-3 V3 SE

Rafts:

Doesn't Matter

Supports: 

No

Resolution:

0.2mm

Infill: 

20%

Filament: Creality Hyper-PLA Black Post-Printing

Activate Water Level Floater

Simply push down lightly on the floater to break the small internal stick holding it in place, and you're good to go!

Category: Outdoor & Garden