Can be used to mount monitors with an angle. Provides a bit of spacing to fit other mount options (like a raspberry pi case) behind the device. Compatible with VESA 100mm.

You would need M3-M5 bolts with nuts (at least 25mm in length) to secure the hinges. You could print other options as well. You also need some bolts (and washers) to mount the parts to your monitor. These must fit the monitor mounting options.

The double-hinge is designed for the bottom. The one-piece hinge should be printed two times so that you can fit the extension in between. You can extend this yourself to get the desired monitor angle.

Printed with Prusa PETG with 0.2mm layer height.