Printable ring holder that takes up to two rings.

The heart “breaks” if two rings aren't used to hold it up.

Works with various ring sizes, just use the hole that suits your ring best.

Regular file works great with my P1P.
If you find the fit too tight the bigger version should work.

Requires 4 M3 screws. I found 20mm works best, 16mm also works. You can put a M3 nut on the end with a drop of glue as a ring retainer, but I did not find that to be necessary.

Assembly: 

1. Place a screw through the back of each hole on the center stick
   
2. Place a screw on either side, pick the hole that suits your ring size the best
3. Place in stand
    

Uses a modified version of Aldoliquid's hinge