Chipsticks v2
r0omista
Trouver des similitudes avec l'IA
Profil d’impression(0)
Fichier modèle(0)
1
0
0
Publié:2026-01-05 10:12:32
0
0
100Description
Source du modèle
Avis(0)
This is the v2 after less than 24 hours posting of v1. It should be much better when used to pick small and light snacks like potato chip, beans, French fries, etc.
Learnt from v1 that the tabs at the back of the fingers are not needed. Removing it makes a clean design.
Print Settings
Printer Brand:
Creality
Printer:
Ender 3 Pro
Rafts:
No
Supports:
No
Resolution:
0.2mm layer height
Infill:
0%
Filament: No Brand PETG Clear
Notes:
Two walls with no infill. I used 0.6 nozzle and the line with is 0.6mm. As always, check you slicker before print. My Cura prints broken inner wall on some layers. New beta engine solves this problem but I choose to use a slightly thinner inner wall of 0.56mm to solve the problem. If you filament is dried and flow is accurate, it should be printed without any stringing issue or blobs.
Source du modèle
Lien original: Voir les détails
CC-BY