I had my webcam on my desk, but my boss said he didn't like looking up my nose.

So I built a stand out of a couple of hunks of 2x4, and that was OK but was pretty clunky, so I built this, and it's much smaller and cooler.

It prints flat, so it's quite strong, and press-fits tightly.

Full disclosure: I cleaned up the OpenSCAD file quite a bit in preparation for publication, and I haven't printed it since that cleanup. It looks OK.

Craftbot Plus

No

No

0.3mm

I wanted to design this in assembled form, but of course I also needed to render it in printable form. I experimented with animating it between the two forms. You can force it into assembled form by setting the animation time to zero, or into printable form by setting the animation time to 0.5.