Most salmon fenders are meant to simulate a school of fish by thrashing a big piece of plastic around during trolling. I'm not sure if the fish actually know, but it's unconvincing. This is meant to be a 3-or-more piece fender printable modular and added to as needed. You can hang it off your trolling rig or off your downrigger weight like any other salmon flasher. All the hardware came off a walmart shelf.

Print Settings

Printer Brand:

SeeMeCNC

Printer:

Rafts:

No

Supports:

Resolution:

.10-.20

Infill:

Notes:

Print with high infill. The base piece is meant to be printed flat, then carefully using a butane torch, boiling or off-boiling water, or a very hot hotbed, heat the piece and shape it as per the video. You may attach as many of the bases printed to a smaller ratio inline behind it with the fish pieces printed and places laterally. Attach reflective stickers and/or epoxy resin. Attached video printed at 100% at .2 layer height in Atomic PETG.

Category: Sport & Outdoors