A stand for Thor's hammer (Mjölnir) or just any normal hammer!

Inspired by Freek2211's model. I modeled a new base in Fusion 360 and added the text from their model to the front.

Printing

In the slicer put the part on the side opposite to the text so the text prints well and without any supports. You can use PrusaSlicer's “Place on face” feature to align the model on the buildplate and “Cooling thresholds” in Filament Settings in order to make the text a little bit nicer at the end.

I recommend printing the model at 0.2mm layer height with a 0.4mm nozzle. I also used 4 perimeters, 3 top/bottom layers and 15% support cubic infill. I printed mine in 3 hours and 45 minutes using 36 meters of filament.

---

There isn't a 90° angle where the hammer stands so it's better if the hammer is a little bit more heavy (it's a 98° angle for dramatic effect actually, surely it isn't because of my bad design).

The hammer I used in the pictures is a Parkside bottle opener, made mostly out of plastic and a little out of metal for the bottle opener part. I attached two 5x3mm magnets on the stand so 36151 the hammer stays in place.