A stepless angle bracket for mounting 6015 COB LED strip.

This is a component of an ongoing project, for providing adjustable LED light sources.

However, I think this can be practical in a variety of cases, the two M2 holes in the base can be used to fasten it to aluminum profiles for a 3D printer.

If M2 screws are not available, two pieces of 1.75mm filament can also be used as the shaft, and attach the LED and bracket with VHB double-sided tape.

When using layer height of 0.1, the M2 nut can fully slide into the groove. When using layer height of 0.2 I have to heat set the nut with a soldering iron to help it sink into the groove.

Print Settings

Printer:

Voron 0.1

Rafts:

Supports:

No

Resolution:

Infill:

15%~30%

Filament:

PolyMaker PolyLite ABS

White

Category: 3D Printer Parts