The proteasome is the cell's recycler. Within this barrel-shaped complex, proteins are literally torn apart and chewed to shreds. How is such a brutal destruction machine controlled? Well, through the use of various caps and adaptor complexes of course!

This set of models includes the regulatory complex from trypanosomes (1FNT) "proteasomecap.stl"; the activator complex from yeast (1VSY) "proteasomeactivator.stl"; and finally the ubiquitin identifying complex also from yeast (4B4T) "ubidentifier.stl"

Each regulatory complex has also been modified to contain pegs that fit into holes in the flat sides of the proteasome barrel. Thus, each complex cam be attached reversibly to either side of the proteasome, assuming your printer is properly calibrated.

Go here to learn more http://tinyurl.com/dyrf9hd

Instructions

I printed this at 0.15mm layer height, 0.45mm extrusion width with natural ABS; I used KISSlicer's "dense" support setting and scaled the support flow rate to 70%.

Removing support from inside the proteasome barrel is very difficult; I used a piece of armature wire stuck in the holes in the walls between the subunits. That said I did print a lot of these things before I got tired of them so I think it's totally worth it.