This is a super simple vertical laptop stand.  Fits most non-gaming laptops with a little wiggle room.  This is useful when desk space is at a premium and you happen to have a dock or other means of wiring in the laptop without having to have the thing open.  I put some rubber feet on the bottom of mine to keep it from sliding around, but some tape or poster putty will work too.

A quick note about the surface finish… I ran out of filament about half way through and had to switch to another roll of black filament and it turned out that they were not quite the same.  

I recommend printing this in PETG so there is some flexibility in it, but PLA would work fine when printing in the provided orientation.

Enjoy!