These two models are printed at:

• .2 mm
• 10% infill
• No brim
• No supports

The 2x1 version I used magnets to make it more stable and not just tip off. NEEDS magnets, otherwise it was annoying.

2x2 Version does not need magnets per say.

Here is the model of the base I am using on my MK4S.

This is a great way to keep your cleaning alcohol near by to get some quick cleaning in between prints!

Below are the products that fit inside, but other containers could probably fit. The diameter will need to be < 66 mm.

Alcohol Holder Pump: https://amzn.to/4eo3I0w

Cotton Scrubs: https://amzn.to/3zwn1Wh

Magnets: https://amzn.to/47Ob3nn