This is a wet palette for acrylic model painting. The top is held on by magnets, and is ergonomically designed to grip and open easily. Here is an explanation of the included files:

WetPaletteV5Top.stl - Top cover of the palette
WetPaletteV5Bottom.stl - Bottom cover of the palette
WetPaletteV5TopCap.stl - Decorative patterned top surface of top cover (see notes)
WetPaletteV5CutTemplate.stl - A template used to tear properly sized sheets of parchment paper for use in the palette
WetPaletteV5.ini - My PrusaSlicer settings for the top and bottom sections of the palette
WetPaletteV5TopCap.ini - My PrusaSlicer settings for the decorative patterned surface of the wet palette top cover
WetPaletteV5CutTemplate.ini - My PrusaSlicer settings for the tear sheet cutter template

NOTES:

(1) The palette can be resized up to roughly 10% smaller. Smaller than that will result in the magnets not fitting in the recesses.
(2) The Top Cap is not required--it is only decorative.
(3) Both the Cut Template and the Top Cap are made with special slicer settings, such as no top and/or bottom layers (only patterned infill). Refer to the ini files for these special settings.
(4) This is designed for 5mm diameter, 1mm thick magnets. They are easily available at Amazon (search).

Qidi X-Plus (modified with E3D Hemera and borosolicate bed)

No

No

0.2

varies (see ini files)