Edge guide attachment for Ryobi PCL424 Trim Router.  It allows several inches of adjustment and has ¼" marks along the bottom to help measure and ensure staying square.

Needed:

M5 x 20mm bolts  QTY: 2 (for thumb screws to hold on edge guide)

M5 x 16mm bolts   QTY: 1 (for holding on handle)

M5 heated inserts  QTY: 3 (2 installed in edge guide, 1 installed in handle)

Print: 

Base plate with numbers along the build plate

Two thumb screws

Edge guide

Handle (I printed it laying down so layer lines add strength)

Edit: I have replaced the .stl file for the edge guide with one that has the correct holes for the M5 insert.  The original included one was skewed from making it wider in V2, I did not properly account for the mounting holes.  This has been corrected now.