This design uses the original extruder mount as a base mount for a filament runout sensor, consisting of a creality z-stop switch. In my case the switch labeled with "2030". The author of the original filament sensor, which I use here, tested the design with an "1830".

For my switch I didn't need any screws to fix the board. Your mileage may vary.

I removed the cable guides, as i don't need them.

These are my first steps in CAD (Even if it is only a remix), so please be gentle.

Print Settings

Printer Brand:

Creality

Printer:

Rafts:

No

Supports:

Resolution:

0.12

Infill:

Filament: Das Filament PLA Black

Notes:

Category: 3D Printer Accessories