This is a suite of files. The first two, Octofallopio1 and OctoFallopio-NoTop, are single wall vase mode, corkscrew, designs. The two files are ~152mm tall, but of course you can scale or slice them to make a bowl, for instance.

However, setting everything up for vase mode and then changing the vertical walls to two layers will yield a more water tight vessel. Remember to leave the top layer at zero.

The other two files are heavier walled designs not intended for vase mode, corkscrew, setup. I used 10% fill on these two. They are water tight and heavy. They also take much longer to print. About 3 hours for ~100mm tall. If you are patient, scale larger.

I used Prusament .2mm layers on all versions.

Print Settings

Printer Brand:

Prusa

Printer:

Rafts:

No

Supports:

Resolution:

.2mm

Infill:

Filament: Prusament PLA

Category: Sculptures