This is a hanging shelf for the IC-705. The platform has a recess that matches the underside of the radio to keep it in place. I'm able to depress all front panel controls without the radio moving around. (As long as you're not stabbing at them with hard pressure.)

I made this for my particular needs with keeping the radio up out of the way in my RV's radio desk. It occurred to me that others might need a way to hang the radio up under a shelf as well, so I thought I'd share the parts.

The bracket part provides enough clearance to get a finger tip on top of the radio if you need to stabilize your hand while operating the front panel controls.

The shelf is too wide for many printers, but I found if I rotated it on the wide end and put it on my build plate diagonally, it printed just fine.

Print Settings

Rafts:

No

Supports:

Resolution:

200

Infill:

Filament: PolyMaker PLA

Category: Electronics