Summary

Hi,

This is a servo mount for a MG90S micro servo. Other standard size micro servos should fit this too.

I designed this to be a quick and easy print with no supports and to be hot glued into my foam board RC plane. The mount is also very light weight at only 4 grams.

I've seen most servos in foam board planes just hot glued into place but i wanted the option to remove/swap out/repair the servos without damaging the the plane or servos. this mount allows good adhesion to the mounting surface while being light weight and supporting the servo nicely.

If you want want to use screws to mount the bracket, this can be done very easily by drilling holes on the flat surface and using counter sunk screws. This would also be a good mount if you wanted to use double sided tape.

As usual, comments and advice welcome :)