Heavy duty design to mount the BN-880 or M8 GPS modules to the TBS Source One frames. Can mount on the front or rear of the frame. 30mm x 42mm hole pattern. Slightly round the corners of the GPS module boards - just break the corner - to allow it to easily fit the recessed area. There is a relieved area to secure the module with 3-4 wraps of 1/2" (13mm) Kapton tape before screwing it down. Bottom plate is 3mm thick for durability! 10mm hole allows easier removal of a taped down module.

This also fits the iFlight Lawson Battleaxe frame if mounting the GPS in the rear. Works great with toilet tank top mount or bottom mount battery. If your quad has 30x42 mm screw pattern on the top plate then this piece should work.

Update 7/11/20 : Just added a new file to hold the smaller M8 style module from RDQ, TBS, and others. Also changed the parts to allow the wires to come up in front of the top place behind the camera and running under the mount before entering the module. Makes for a very clean installation and the wires are completely protected.

XYZprinting

da Vinci 1.0 Pro 3in1

No

Yes

0.2mm

Print with light supports for the cabling access port. Apply VHB tape to the shielded area of the module only if not using Kapton tape wraps.

I've tested this in both PETG and TPU. The TPU version is nearly indestructible when printed at 100% fill.