Simple solution for drying wet mittens on top of bathroom water battery heater.

Two part print, top part is 15cm long where mitten goes and bottom attachement to hold it in place, friction fitted between battery and wall. My wall to battery has 30mm clearance, so i also included step file if you need to change the depth.

Print settings

STL files are in correcly oriented, bottom part has small slope to help with vertical inset wall for top part, check screenshot.

• 0.2-0.26mm layer hight
• PETG suggested
• 20% cubic infill
• 3 walls
• 3-4 bottom/top layers
• ~28g filament required
• supports: no

Assembely 

• 1x M3 screw 12mm, can be longer, doest matter. Screwed from the bottom