Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

 The Model is 200x200mm in size. You can change X and Y but Z must remain the same.

 You may print at higher layer heights below the Min Depth of 0.48mm

 Actual Depth is 2.2mm

Filaments Used:

PLA BambuLab Basic Red Transmission Distance: 4

PLA BambuLab Basic Orange Transmission Distance: 5

PLA BambuLab Basic Yellow Transmission Distance: 6

PLA BambuLab Basic Black Transmission Distance: 0.3

PLA BambuLab Basic Blue Gray Transmission Distance: 3

PLA BambuLab Basic Dark Brown Transmission Distance: 2

PLA BambuLab Basic Beige Transmission Distance: 8

PLA BambuLab Basic White Transmission Distance: 5

This print uses 8 unique filaments. Substitute as needed.

Swap Instructions:

Start with Red

At layer #8 (0.72mm) swap to Orange

At layer #10 (0.88mm) swap to Yellow

At layer #12 (1.04mm) swap to Black

At layer #19 (1.6mm) swap to Blue Gray

At layer #20 (1.68mm) swap to Dark Brown

At layer #22 (1.84mm) swap to Beige

At layer #23 (1.92mm) swap to White for the rest.