2018-12-12 added my gcode files from Jan/Feb 2018. Use at your own risk.

2018-05-24 added Fusion 360 and step files for easier remixing. Hopefully I will get back to modifying this again, but for now, happy remixing.

2018-02-04
In my quest to make my printer more quiet, I came up with this idea since the i liked the power supply cover by ml_blh. (https://www.thingiverse.com/thing:2715000). I installed his cover and 2 new fans. Just doing that decreased the frequency of the PSU fan on time. (also quieter fans are more quiet.) The only trouble with the PSU cover was the base bottom cover did not fit, and I still needed to put the feet on some blocks so the cross bar would not touch the table.

This base is 20 mm tall and attaches with the standard screw locations. (hopefully. I printed the first section with 3mm holes and had to open them up with a drill, but since then have changed the model to 3.5mm) I recommend 20mm long screws and don't tighten them too hard or you could run them into the screen or the PSU cover. The threaded holes for the standard feet are modeled and I had no trouble getting the screws in for them. I did use some longer ones, but I think the stock ones should do well. If you use similar print settings, I don't see why they shouldn't work for you.

There are mounts for two 60x25 fans. I am using Noctua (NF-A6x25FLX) with the "low noise" filter to continuously pull air from the front to the back of the unit. (Only one pictured because I needed to order another one still.) They are wired up to the extra power supply taps and I suspect with them running full time, the PSU fan on time will be lowered even more.

The holes in the front are for a switch I found on Digikey (part number: PRK22J5DBBNN by ZF Electronics.) I use the one for my lights and haven't found a use for the other hole yet, but in the mean time it will just let more air flow through.

Anycubic i3 Mega Ultrabase

No

Yes

.2

30

Supports: Yes
I use Repetier-Host with Cura Engine
2mm thickness.

On a few of the prints, the y axis would bounce off the limit switch because the support is bigger than the actual part, but it didn't give me any issues, just a bunch of beeping and clicking every once in a while.

All together I used about 585g of plastic, but that should go down slightly since I lowered the fan mount a bit after I printed mine.

I basically used a ruler without zero at the end to make this thing, so I think it turned out pretty good fitment-wise.