Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

 The Model is 200x200mm in size. You can change the X and Y but Z can remain the same.

 You may print at higher layer heights below the Min Depth of 0.48mm

 Actual Depth is 4.5mm

Filaments Used:

PLA BambuLab Basic Black Transmission Distance: 0.3

PLA BambuLab Basic Blue Gray Transmission Distance: 3

PLA BambuLab Basic Red Transmission Distance: 5.5

PLA BambuLab Basic Beige Transmission Distance: 8

PLA BambuLab Basic Jade White Transmission Distance: 5

This print uses 6 unique filaments. Substitute as needed.

Swap Instructions:

Start with Black

At layer #17 (1.44mm) swap to Blue Gray

At layer #21 (1.76mm) swap to Red

At layer #27 (2.24mm) swap to Black

At layer #31 (2.56mm) swap to Beige

At layer #45 (3.68mm) swap to Jade White for the rest.