A topper for the tap handle of your Perfect Draft beer dispenser machine.

The supplied topper 'buttons' are only readable from above and you need to buy a new one for each different beer keg (assuming you can find the right one). This design allows you to print your own label and have it visible from the front of your machine. You can easily print (2D!) a new label for every type of keg you get and they will just slot into the holder.

As with the standard buttons, the topper is attached magnetically to the top of the handle. A magnet can be glued or stuck with double-sided tape to the bottom of the topper. If you have a particularly thick or thin magnet, you may need to adjust the height of the bottom part of the print or use some packing as the magnet needs to be a close fit to the bottom of the hole in the handle.

It works well with a 2.6mm thick magnet and 0.5mm thin double-sided foam tape

Creality

Ender 3

No

Yes

20%

You will need supports for the base and for the top of the holder frame. Be very careful when removing the support for the top frame as the support will be a lot more robust than the top of the frame.