Here's a Xpresso pod that I quickly created to test my newly acquired Fusion360 skills. Was surprisingly easy. I don't yet have any particular use for this Thingy, but at least it seems to print out pretty OK.

Update: In v2, the pins that lock the lid in place have been moved to the lid and the cup has the holes. This to allow printing the cup "mouth down" without any supports. [V1 STL-files still available in the zip, should somebody want them.]

NOTE:
Please notice that the combined thickness of the rim and the lid is 2mm whereas the corresponding dimension in the original pod is 1.5mm. If this will be a problem, I will thin it down in a new design release.

Anet

A8

No

Yes

0.1

100

Drill (very slow rpm!) the holes to 2mm .

2 hours fron scratch to finish.