Took me way to long to notice, I never published my changes and got the files mixed up when I first uploaded this.
Original file was what I remixed, removed that from this page. Now the modified version with the extra slots and holes that match photo is uploaded here.
Sorry!!

I know a remix of this is not original. Yet I felt there were a few improvements that I enjoy having.
First and foremost. I added a circle to hold a gluestick. I initially made this a tiny bit smaller and ditched the cap, yet I felt that was excessive and may lead to drying, so I made it like .2mm bigger (diameter) and the cap fits snug, yet not tight.
There are also two holes that can fit extra nozzles.
I also flipped my model in my slicer software and printed this twice. Once normal and again a mirror image. This allowed me to hang two of them, one on each side of the printer.
I am not the first to add a holder for the USB microSD card reader, I also added an extra slot. You can fit a lot of things in this such as a caliper or another wrench.
Other than that I don't believe I did anything unique compared to the MANY other remixes of this design. So thank you to DantRush. I am pretty sure he is the original designer.

I would recommend as much infill as you want to give this. The clip pieces that plug into the 2020 rail, at lower infills (<20%) had a tendency to snap off.
Oh and the scraper holder. This is a tight fit. Just keep inserting and removing. It will eventually loosen up and fit OK. I tried to make this slit bigger, however making it to wide lead to some weakened end results. So scraping away at a knife or using the scrapper itself seems to be the best. Feel free to play with scaling if you want.

Also I added it, yet I never use it. I made a recessed section in the back,. The idea was to give a little shelf like piece, however it is small and shallow, that I never got much use out of it. So if you do, great. Please comment so I have an idea what to use it for.

Creality CR-10S

Doesn't Matter

Yes

.2

above 20%