If you have any of the old 70's Mattel Electronics sports handheld games this is a replacement battery cover for them. It was designed off a Mattel Electronics Baseball game but they all used the same cover. Print it in the closet color filament you have to match your game and enjoy.

Note: I did have to print this with supports for the tongue to come out correct. I used supports every 1mm but you could probably get away with 2mm or 2.5mm spacing. Also I printed this in PLA and it is much stiffer than the original plastic the game housing is made of so be careful when removing so you don't break your game.

Prusa I3 MK2

No

Yes

0.15

20%

To make it easier to remove from your game you may want to trim down the height on the catch on the tongue.