An Electric Vehicle charger cable holder / tidy to neatly hold the coiled cable when the charger is not in use.

I was unimpressed by the small metal bracket that came with the Wallbox Pulsar Plus car charger, so I designed this one to replace it using Fusion360.

This should offer better protection for the cable when it is stowed away and not in use.

The screw holes match the metal cable holder that was provided with my Wallbox Pulsar Plus, so swapping this over should be easy. Although designed to complement the Pulsar Plus this could also be used with other manufacturers chargers or for other situations.

Print instructions

I printed mine in Prusament Galaxy Black PETG to provide a stronger print than PLA, because it is located outside. ASA would probably be even better, providing protection from UV etc.

Best printed with a brim, to help hold the corners down, as this is a large print and the corners could lift off the bed.

It should print successfully without any support.