Screws or mounting tape required (screws recommended) mounts under a desk/table or sideways or whatever you want with the Xbox One S/X or the Xbox Series S. Feel free to sell these, just link back here plz.

No

No

0.4 or better

100

0.4mm nozzle is recommended at 0.4mm height per layer or more detailed; it doesn't matter. These print really reliably if initial adhesion is good & the nozzle temp isn't too high. More than reliable, no it wont fall even if mounted very jankily... lol
Prints sideways.

No supports meaning no waste material :D