I wanted to create a eye catching knife holder. But i wanted it to be as functional as possible at the same time.

Because of that i had to make a few design compromises.

Knives sticking bare out of the back of the skull will for sure look cooler, but the added risk of slicing your hand open with razor sharp blade is not cut it for me.

Skull has compartment inside that can store full size whetstone, albeing it sticking out of the back a bit.

Floor of that compartment is full of holes to allow moisture to escape from the stone.

Storing the stone inside ha s the added benefit making it less prone of tipping over.

You will unfortunetly need to use supports to print this

Unfortunetly printables would not allow the use of a link as a remix parent. So i have to post it in description.

https://cults3d.com/en/3d-model/various/crane-humain-cerebrix