Using no additional hardwear.

Print bolts on using stock hardwear, stock rubber foot is a press fit sleeve and pin into the print, requiring no bolt.

Mostly just for the looks, but also increses the stability of the machine by increasing the footing, reducing mechanical advantage print accelerations have on the chassis.

Increases machine foot print from 400*x410* to 470*x 480* (around 35mm per side), this is negligible as the screen, spool holder, filament poop draw and glass top holder most people have printed and added to their machines inceases the foot print of the machine by around 50mm on each side anyway.

Raises machine 10mm.

Print:

3x v1.7 Foot

1x v1.7 Foot PSU (has cut out to go around PSU switch)

Printed in PLA or PETG:

3 Walls

15% Infill

Alternate Extra Wall

4 Bottom Layers

5 Top Layers

Normal Support (probably not needed just leaves a cleaner mating surface for rubber foot)

31g total per foot (32.5g with support)

Upload your make's to get Pursa Points and so i can see your builds.