These are router templates for creating the necessary indentations to flush mount sewing table hinges.

There are two versions:

• "Schablone flach" + "Schablone tief"
• "Schablone flach groß" + "Schablone tief groß"

You need both elements of either version. Hold them down to the table with double sided tape. The necessary depths for my hinge models were 2 and 6.5 and that's why you find those values on the models. This might be different regarding your hinges, so take some decent measurements.

If you have a very heavy and big router, use the bigger ones ;-) - I used the Makita/Katsu trimmer at first and it was totally fine to use the smaller ones.

And... I did not print the hinge, the STL is only for reference...

Print Settings

Printer Brand:

Anycubic

Printer:

Rafts:

No

Supports:

Resolution:

0.2

Infill:

Filament: unknown PLA