Im sure this is a remix of a similar design but with a thicker base to accommodate the use of double sided tape. I have downloaded other plates similar but the backing plate was too thin to accommodate the use of double sided tape. The hooks would break out of the thin plates and creating a thicker backing has solved the problem.  These work very well with 3M's VHB tape or even Alien Tape from Costco. If you are going to mount them with superglue I recommend a light sanding with 80-120 grit sandpaper and cleaning with rubbing alcohol for a good bond.

Since I could not find the original file I designed this one from the ground up although I am sure it is very similar to others posted.

Printed with Rep Rapper's florescent red PLA with the following settings:

Nozzle temp - 213*C

Bed Temp -60*C

Walls - min 5

Supports - Everywhere.