Summary

This is a body/spacer for a GPIO pin spacer for the Flipper Zero. Why do we need that? Well, we don't really unless you want to be able to use all your modules with the silicone case still on your Flipper. Which I do! So here we are. People sell these things, so I suppose that means there's interest.

For this to work, you'll need a 2x8cm PCB, and some terminals, (of the 8 and 10 pin variety). Exactly where to solder them in to work with this body is shown in the images. In short, the body fits over and supports your terminals and covers the top part of the board with a simple case.

No supports! Just flip it so the bottom, (wide end) faces up, surface the top to your build plate and do the thing. It turned out well for me at as low as 20% infill with ESun PLA+.