Crosman 1322 suppressor
F3rrick
Trouver des similitudes avec l'IA
Profil d’impression(0)
Fichier modèle(0)
0
0
0
Publié:2026-04-05 13:23:53
0
0
000Description
Source du modèle
Avis(0)
A remix of Crosman 1377 suppressor V2. The original was a 5mm hole for 4.5mm (.177) pellet. This has a 7mm hole for 5.6mm (.22) pellet. I also made this a two piece threaded design. This makes managing supports simpler. Also, if you break something while installing the barrel band, you only have to re-print the barrel band instead of the whole thing. (Previously... print / wait 17 hours / install /snap / D'oh!)
I made some improvements to the fit (and I might make some more in the future). I made the pivot pin hole a bit larger. I also cut out some plastic between the barrel and air tube. I found the original lifted my barrel a bit. I still had to drill out the barrel hole just a bit. There's also some tabs on the part that insert into the air tube. I think they're there to ensure a tight fit. I just sliced them off with a paring knife.
Tinkercad: https://www.tinkercad.com/things/jvVJxgbGmf5-threaded-1322-suppressor
Print Settings
Printer:
Adimlab Gantry
Rafts:
Doesn't Matter
Supports:
Yes
Resolution:
0.16
Infill:
65 on suppressor, 80 on barrel band
Filament:
MG Chemicals PETG
Notes:
I used supports on the barrel band (touching build plate only). You will likely have to drill out the barrel hole a bit. You might have to sand the concave plastic area between the barrel and air tube to ensure the barrel is level with the air tube. In the uploaded model, I removed a bit of plastic to avoid having to do this, but haven't tested it yet. I used 150 grit sandpaper and an old chop stick.
Source du modèle
Lien original: Voir les détails
CC-BY