This is a throttle lock that I've modelled for my 2017 Suzuki V-Strom 1000. I would not be surprised if it fits on other makes and models.

First and foremost (got to cover the legals...) throttle locks are dangerous and perhaps even illegal where you reside. I'm sure you already knew that.

I modelled this because I was tired of giving up real estate on my throttle grip to other types of similar throttle locks. My hand was pushed to the very edge of the bar - just uncomfortable. This one fits onto the flange of the rubber grip and therefore frees up the rest of the space for my hand.

My design is flush on one side so it does not interfere with the throttle cable housing. This is the reason why the finger-wheel is offset to one side. I have not yet tested it on the road, but it seems to work just fine in the garage.

The hinge is all one part with 0.5mm 'air' gaps. It came out a little too loose. I'm keen to go a little tighter for the next print.