Mini Screwdriver

This is a remix of LoboCNC's 15-in-1 Reversible-Ratchet Mini Driver.

This mini screwdriver uses normal-sized bits instead of mini ones. It can also hold six bits in the handle.

Printing instructions

I printed it in PLA but PETG or ABS should also work.

Print at 0.2mm layer height or finer, 20% infill, 2 or more perimeters.

Assembly instructions

1. Get rid of any bumps on the parts
2. Slide the top over the middle top
3. Slide the ratchet over the middle top with the hole facing up
4. Insert middle into middle top
5. line up the holes on the ratchet and the middle parts
6. Insert a small piece of 1.75mm filament into the holes
7. Insert the assembly into the driver body
8. (Optional) Put the washer over the middle piece on the back 
9. Screw the bottom piece onto the diver body
10. Pull and push on the middle piece to switch the ratchet direction