Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

 The Model is 200x200mm in size. You can change X and Y but Z must remain the same.

 You may print at higher layer heights below the Min Depth of 0.48mm

 Actual Depth is 2.2mm

Filaments Used:

PLA BambuLab Basic Black Transmission Distance: 0.6

PLA BambuLab Basic Blue Gray Transmission Distance: 3

PLA BambuLab Basic Silver Transmission Distance: 0.5

PLA BambuLab Basic White Transmission Distance: 5

PLA BambuLab Basic Red Transmission Distance: 4

PLA BambuLab Basic Orange Transmission Distance: 5

This print uses 6 unique filaments. Substitute as needed.

Swap Instructions:

Start with Black

At layer #7 (0.64mm) swap to Blue Gray

At layer #8 (0.72mm) swap to Silver

At layer #11 (0.96mm) swap to White

At layer #15 (1.28mm) swap to Red

At layer #21 (1.76mm) swap to Orange for the rest.