Print Settings

Printer:

Punchtec Connect XL
Rafts: No
Supports: No
Resolution: 0.2
Infill: 50%

Notes:

Print two of either bag_clip_smooth or bag_clip_textured and two of bag_clip_spring. The springs need 50% infill, but the clips do not. bag_clip_textured provides a little bit of texture on the handles to keep the clip from sliding out of your fingers when opening. I had a request for a clip without the "teeth", so I added clip2_textured.

Post-Printing

Put the two halves of the clip together so that the "teeth" mesh together, then slide the springs on from the sides until they click into place.