It was made to mount the C270 camera on the front of the enclosure frame. Currently, the camera cable is being tested by temporarily pulling it out through the gap in the front door. I plan to eventually route it along the inner frame and connect it out through the rear filament spool holder. Accessories for cable routing are still under design.

It was sliced using a prusa slicer and printed with eSUN Solid Black PETG.

For the final printout, a layer height of 0.1mm, 50% infill, support on build plate only, and print speed of 120mm/s were used at 240 degrees Celsius. (Even when I printed in 0.2mm layer height during my initial design, there was no problem using it.)

Installation simply requires insertion over frame gaps. It is fixed by its own elasticity. If you want to fix it firmly, you can use double-sided tape to fix the front side.

(UPDATE) Add spool holders for cables to pass through. Snapmaker J1 spool holder remixed by lemmaa | Download free STL model | Printables.com (Since the license is different, add it as a link.)

(UPDATE) Added a cable guide that can be clipped directly to the left vertical frame