The TIE/AG Aggressor is more or less the imperial counterpart to the rebel y-wing - A fighter-bomber with poor maneuverability and a rear-turret. But unlike the y-wing it has no bombs, hyperdrive or shields. Although the TIE Aggressor has been reintroduced into Canon, it is yet to appear in any prominent role.

This is a model at 1:270 scale. Its 30.4mm long, 27.4mm wide and 18.6mm tall. The turret can rotate and is print-in-place.

For a holder, it is compatible with a small peg, pin and base.

Print Instructions

Printed at 0.1mm layer height.

Rotate by -90° along the x-Axis so that the engines point down towards the printbed and the cockpit points up. (This reduces the amount of supports.)

Set supports to buildplate only and add “tie_aggressor_blocker” as a support blocker. (Right-click on the model → add support blocker → load… → select file “tie_aggressor_blocker.stl”)

If you want to support me, you can do so via this link: https://ko-fi.com/printingdaniel#