This is a tool mount for the Craftsman V20 series tools, you can mount vertically or horizontally. I would only recommend using this on the smaller tools. I designed a snap in mounting system that works on a peg board, but you can mount it on a wall also. I have added the peg board mount also.

I printed mine flat on the bed at .28mm layer height with supports, which should give it better strength and allow it to slide in easier into the tool. I recommend cleaning the rails with a deburring tool. Make sure there are no blobs, or it will cause too much resistance when trying to slide it in.

[9/22/2025]

I added a latching tool mount. You will need two cheap mechanical pencil springs (11mm long and 4mm wide). The tool mount will need to be printed with supports. You will also need two M3-10mm screws, they can also be a little shorter or longer. This is very basic but should work, I wanted to make it simple and reliable. You may need to work the part up and down for it to move more freely, it all depends on the tolerances of your printer. You can also file it to smoothen the layer lines.

Fixed “Craftsman V20 Tool Mount” and “Craftsman Tool Mount No Logo” manifold issues.

Hopefully you find this useful.