I saw doppiozero's design for a rough terrain glass holder and thought it was a good idea but had 2 drawbacks. It was too large to print on my Ender 2 and required a significant amount of support structure to print in either orientation, so I came up with this design that is slightly smaller and does not require any support or rafting. The holder is designed to hold a “Red Solo Cup” and will nest for stacking, but will also steady can drinks as well. I put holes in each foot so that if it is windy, you can use nails to secure it to the ground.

Ender 2

No

No

.2 to .3 mm (I use .25mm)

any (I use 25%)

Make sure that your bed is level