Update: New version ("PhantomLeg2") gives the foot a little more area and makes the fit a little snugger. I printed a set and they mount well, though one cracked when I mounted it. These can be zip tied on, or just used as a press fit.

I needed so raise my Phantom 4 Pro just a little higher off the ground. I couldnt find any existing design that worked well with the 4.

This is a work in progress. Currently designed to raise the Phantom about 20mm. It uses the soft strip on the bottom of the legs to stabilize and 2 zip ties to hold it on (though it should also just clip on).

I will refine this further, currently it does not clip on too strongly, and the zip tie holes (on my printer) came out just a little tight (but could be expanded a little to work).

Wanhao

Wanhao Duplicator i3 V2

No

No

.2

25