A little Ikea Hack for the Sniglar Changing table (200.452.05).

You can add a mesh basket drawer below (590.109.88) by buying the Pax drawer in 50cm large and printing those items:

• 1x Front Right adapter
• 1x Front Left Adapter
• 4x (or 2x) Back Adapters

I just needed a few wood screws (30mm length is good for the front, 35mm for the back adapters is ideal).
Pre-drill the wood for a better finish.

Steps:

• Attach the front support to the underside of the table using screws (30mm).
• Secure the drawer rails firmly to the front support using the ikea hardware.
• With the drawer fully closed, position it in place and press it into the rails. The drawer is designed to snap in rather than slide, which prevents a child from lifting it out.
• Attach the back support to the rails using the ikea hardware.
• Secure the back support to the underside of the table (35mm screws).

Creality

Ender 3 Pro

No

No

1mm

50%