So this is a shield design I made for separate multi color printing. Everything should fit pretty well, but the face might fall down into the hole of the sun part. I need to add a little ledge to catch it, and I also want to add some way to hold an led or three to light up. If only I could be so grossly incandescent.
Also there are 2 sun cuts, a 12mm and a 14mm. The original print was 12mm but it's a little short so I resized it. I haven't had a chance to print the 14mm version yet, so no promises.

Sovol Sv01

No

No

.2

100%