Original Artist Credit: Kendra Storz

Originally meant as a quick sketch for a tattoo idea, I used Fusion360 to extrude different areas of the 2D art to make a cute little magnet.

This was my first print on my new printer, so the ones pictured are not quite perfect (used some older material for testing), but it came out very clean with newer material on an established machine.

Print dimensions: 60x60x7mm (7g)
Magnet dimensions: 14.5x3mm
The hole depth is set at 2.8mm to allow the magnet to not sit quite flush so it is easier to grip and remove from the surface.

Anet

A8

Cura did not want to print the thin lines, so please check your settings. Thinnest line is 0.3mm.

Tree support was a little bit better at maintaining the bottom of the magnet hole, but didn't really save much time when cleaning it out to add the magnet. if your material tends to sag, probably a good idea, but you can definitely get away without it.