Notice

This propeller is a work in progress and a video on how to remove the supports will be coming soon.

Introduction

Creation

I'm back and now with the new 3-blade propeller! This propeller is made to generate some thrust on a small model plane. Further information will be provided below.

Specs

1. Shaft Hole Diameter: 2.25mm (Recommended that the motor shaft diameter is 2mm or less to provide 0.25mm tolerance)

2. Blade Length: Approximately 45mm

3. Blade Connection Point Radius: (The cylinder in the middle which all the blades connect to): 7.5mm

Creality

Ender 3

Doesn't Matter

Yes

0.2 mm

10%

Removing the supports is difficult but there is an easy way which I'll make a video on soon, if you are more experienced just remember to very carefully remove the supports as the blades are only a couple of mm thick.